The Anycubic ABS 3.0 Water-Washable resin is designed for a simple and safe workflow: it cleans with water only, offers low odor, low shrinkage and a stable flow thanks to its low viscosity, even in cool environments. Ideal for miniatures, functional prototypes and parts with tight fits.

🎯 Key advantages

• Water-washable: post-processing with water; fewer chemicals and lower cost.
• Balanced toughness: less brittle parts; suitable for light drilling/threading.
• High precision + low shrinkage: reliable dimensions and sharp surfaces.
• Low viscosity: fast reflow and reduced print times.
• 405 nm compatibility: suitable for LCD/DLP 3D printers (optimal performance on Anycubic).

🔬 Typical properties

• Elongation at break: 35–45 %
• Viscosity (25 °C): 400–500 mPa·s
• Hardness: 83–86 HD
• Tensile strength: 36–46 MPa · Young's Mod.: 2000–2950 MPa
• Flexural strength: 36–46 MPa · Flexural Mod.: 2000–2500 MPa
• Density: 1.07–1.09 g/cm³ · DTUL: 60–65 °C
• Wavelength: 365–405 nm

⚙️ Suggested settings

• Layer height: 0.05 mm · Normal exposure time: 2–3 s
• Base layers: 4–6 · Base exposure time: 25–35 s
• Adjust light-off and Z speeds/heights according to your 3D printer (Photon Mono/M3/M5/M7, etc.).

🧼 Use and post-processing

1. Shake well and check that the vat/platform are clean.
2. Print using the recommended settings.
3. Wash with water (agitation or ultrasonic) and drain.
4. Remove supports, sand if necessary and cure fully.
   Tips: work at 18–35 °C; avoid prolonged soaking; monitor intensity and time during final curing.