💧 Anycubic Water-Wash Resin 2.0 – water-washable resin 2.0, precise and low odour

The Anycubic Water-Wash Resin 2.0 simplifies post-processing: clean your models with water only, with low odour, low shrinkage and high precision (minimum detail approx. 0.15 mm). Its low viscosity maintains a consistent flow even at 15–20 °C, improving bed adhesion and print stability. Additionally, the anti-yellowing formula keeps the colour looking fresh for longer.

🎯 The best of this resin

• Water-washable: rinse with water; more convenient, safe and cost-effective.
• More resistant: 16–22% elongation for less brittle models.
• Low odour: a more pleasant printing experience.
• High precision: low shrinkage and crisp surfaces on miniatures.
• Low viscosity: stable performance and fast curing, even in the cold.
• Anti-yellowing: longer-lasting whites and transparents.
• Wide compatibility: suitable for LCD/DLP at 405 nm.

🧪 Properties (typical ranges)

• Viscosity: 190–230 mPa·s
• Density: 1.07–1.09 g/cm³
• Hardness: 82–85 HD
• Tensile strength: 38–43 MPa | Young's modulus: 2350–2950 MPa
• Flexural strength: 48–60 MPa | Modulus: 2300–3000 MPa
• Thermal deformation: 60–65 °C | Mould shrinkage: 2.2–5.5%

🎨 Available colours

White, Grey, HD Grey, Black, Clear, Purple, Smoky Black, Translucent Blue, Green, Red, Yellow.

⚙️ Suggested settings

Compatible with the Photon series (Mono/M3/M5/M7…). General example: layer height 0.05 mm, exposure 2–3 s, 4–6 base layers, light-off 0.5–1 s. Adjust according to your 3D printer and temperature.

🧼 Use and post-processing (summary)

1. Shake well and ensure the vat/platform are clean.
2. Pour into the vat and use the recommended settings.
3. Wash with water (agitation or ultrasonic) and drain.
4. Remove supports, sand if necessary and cure thoroughly.
   Precautions: print between 18–35 °C; avoid direct sunlight exposure of the resin; monitor intensity/time during final curing.

All perishable products, such as resins, are always shipped with the maximum possible validity time to ensure proper use. However, the remaining period may vary from several months to weeks, depending on the batch available at the time of the order and stock rotation.

This product contains photosensitive resin. Use with gloves, a mask, adequate protection and in a well-ventilated area. Do not ingest. See the safety data sheet on the manufacturer's website.